Molding the Candle

As explained, once the candle wax base is ready, it will be transferred to candle making machines.

These machines usually are holding from 50 up to 500 molds. Molds needs to be cleaned and interior surface must be polished before loading the candle wax base for easier ejection of the finished candle. Once the candle wax is poured in molds the wick is pulled to prevent bending of wick.

Then candle wax is cooled slightly by running cold water around the molds. At the time candle wax sets and become solid machine will eject the candles.

Alternative method is to use extrusion. In this process paraffin wax and/or candle wax base is pumped through heated steel pipe under pressure. candle Wax will go around the wick to form candle and at the end it will be cut into specific sizes.

Comments (0)

There are no comments posted here yet

Leave your comments

Attachments (0 / 3)
Share Your Location
Type the text presented in the image below

Related Articles


Which products to use?

Khavaran Paraffin recommends you discuss your specific application with one of our technical representatives to determine the best product.

Go here to use our inquiry form and a professional will be in touch with you.

Khavaran Paraffin Head Office

Khavaran Paraffin Physical Address: 
WEST 3RD FLOOR, NO 251, SHAHID BEHESHTI AVE, ABBASABBAD AVE , TEHRAN, IRAN

E-mail:  This email address is being protected from spambots. You need JavaScript enabled to view it.

Telephone : +982188500596 - 9 / +982188500600

CELL PHONE : +989101450130

Get connected to Khavaran Paraffin